TinyFSK and WinWarbler

WinWarbler is favored by many digital ops for DXing and casual operating.  The following describes setting up TinyFSK for RTTY.

After starting WinWarbler, WW for short, go to config, and in the External Modem tab choose TinyFSK and the COM port for your TinyFSK.  Enter the serial port settings for your TinyFSK: 9600 / 8 / 1 / none.  In the RTTY section, make sure the "enabled" option is checked. Select the appropriate mode for your transceiver for FSK.

For PTT nothing needs to be selected:  Tiny provides PTT. 

In the RTTY tab you will see MMTTY setup.  If you go to that and check on Options,  note that no COM port is entered.  If 2Tone is enabled, note that as with N1MM+ the TX mode will be set to AFSK, which avoids COM port conflicts.  2Tone is not the transmit engine in WW.

The main WW panel should look like this:  RTTY receive and transmit (tinyfsk) is showing.

Note in the green panel, the TinyFSK information is all listed: version, speed, and mark polarity.

N8CL with KD9IWX